Specializing in the production of bus processing machine manufacturers

3-3YK160 Fully Automatic Programmable Bus Processing Machine

Specializing in the production of bus processing machine manufacturers

use  This machine is mainly used for processing copper and aluminum busbars of various high and low voltage power transmission and distribution complete sets of electrical and power transformers. It is used for copper and aluminum busbar cutting, punching, bending, folding and other processes.
main feature One machine and three stations are synchronized in one, and can be used independently at the same time. There is no waste after cutting at the cutting station. The high-precision five-arm punching die set, light source alignment, comes with six common molds, double cylinder blanking device, and punching waste. Smooth excretion, PLC program control and digital ruler equipped with proximity switch device, manual and automatic switching is possible, and the bending angle is simple and convenient.
Station function Various molds such as shearing, punching, PLC program-controlled bending, vertical bending, pressing pitting, flat pressing, and pressing cable joints can be interchanged independently in the workstation, and the matching specifications are optional.
Electronic control function PLC fully automatic control, start at any time, automatic stop, power and fuel saving, equipped with preheating function.

 Bending station  Punching station Shearing station 
     

advantage
1. Shearing automatic downward pressure type, upper and lower rubber devices, easy to cut short rows
2. Guide groove, no waste after shearing, small section slope
3. 3-12mm copper and aluminum bars do not need to adjust the blade gap
4. High-precision six-arm punching die set, easy to use, no need to change one
5. The high-precision guide sleeve punching die has a long service life, high punching accuracy, and saves die costs
6. Double-cylinder blanking device, the punching waste is discharged smoothly, and the convex and concave molds are not easy to damage
7. The punching light source is aligned, the operation is simple and flexible
8. The digital ruler is equipped with a proximity switch device, which is simple and convenient to adjust the bending angle
9. The open design of the bending station is the universal steering punch, which can process special back-shaped bends (U-shaped bends)
10. PLC full program control input: angle mode and height and width mode, solve this kind of angle bending, and quickly increase mass production

The main technical parameters
Nominal pressure 3*350KN
Bending specifications 160*12mm
Punching specification Φ4.3-Φ25
Shear specification 160*12mm
Motor oil station 3*4KW/30mpa/380V/50Hz
Dimensions 1650*1400*1400
Machine weight 1.6T